205
NEW BATHROOM LIGHT SWITCH
FD28603/FD28603-A/FD28603-MМ
This controller integrates multiple functions in one unit, it is designed as a
replacement for the bathroom fan and light switch. By using a microprocessor
to control fan delay-off operation.
The function of Delay Timer provides users an additional run-time of the Fan to
complete ventilating the bathroom after use.
Touch sensor integrated in the unit to conveniently switch light/fan on or off
manually.
Build-in LED indicator situated underneath the front panel, projects through the
front panel to indicate the operation status, the included BUZZER and easy-to-
read display on the front panel ensures zero-error operation.
Specification
1.
Operating power : 230±10%,50~60 Hz
2.
Output format : Volt output, 4 wires connection.
3.
Outputput rating :
Max. Fan : 150 watts @ 250Vac
Max. Light : 800 watts @ 250Vac
4.
Lightning strike surge protection.
5.
Voltage Compensation / power line.
6.
Electrostatic discharge protection.
7.
Delay-timer operational duration:
Adjustable, ranges from 0 to 90 seconds in mode, 0 to 90 minutes
in both and modes
Default Settings in each of 3 operation modes :
Hand wash =Fan 10 Sec. Delay off
Shower =Fan 30 Min. Delay off
Toilette =Fan 10 Min. Delay off
8.
Buzzer :
1)
Buzz upon pressing any key on the front control panel.
2)
Automatic buzz two times when the delay-off operation stops.
9.
Backlight : Constant lit on.
10.
Manual stop delay-timer operation. Bathroom Fan /Light Switch / Fan
Delay Timer Controller
11.
ON/Off status LED indicators in both the Light and Exhaust Fan.
12.
Mounting : 60 mm Flush mount.
Product description
Touch sensors are built underneath the control keys,press the required key to
operate turning on/off the light in bathroom and delay-off the exhaust fan.
Operation guide
1.
Do not connect this unit to aluminum wire. Use with copper or copper clad
wire.
2.
Turn off the main before wiring.
3.
Remove BEZEL and existing switch from recessed conduit box if there is one
already installed, or using any of the provided mounting brackets to install the
controller.
4.
Connect the wires in the recessed conduit box, make sure no bare copper is
exposed. Secure connections with electrical tape.
5.
Mount this unit to the recessed conduit box.
6.
Set the required DELAY time for all 3 DELAY-timer’s operating respectively.
7.
Turn on the main supply and start to use.
Content in package
Controller unit..............................................1
Self-tapping screw 4.6 x 24.5 mm.................2
Plastic anchor ø9 mm x 25 mm.....................2
Machine screw #3 x 20 mm.........................2
Instruction sheet...........................................1
Wiring
DANGER
READ ALL WIRE SIZING, VOLTAGE
REQUIREMENT AND SAFETY
DATA AVOID PROPERTY DAMAGE AND
PERSONAL INJURY
Electric Shock Or Fire Hazard
Disconnect the main before wiring
Set/Adjust DELAY timer (Fan delay off time)
1.
Press and hold for 5 seconds to enter setting mode.
Press to turn on the light
and exhaust fan before
entering bathroom.
Press again to immediate
turn off the light and set
fan delayed off by the
required operational
mode after use of bath-
room.
LED ON/OFF status
indicators are built
underneath the front
control panel.
Press to manually
turn on /off
the exhaust fan.
Reset