213
Deactivation
-
Press the “FREQ”
-
Pressing the key sequence “2” “2” “2” “0”
The action is confirmed with a “beep” twice.
General information on functionality
Parameter storage
The channel selection and volume adjustment are saved automatically every
10
seconds.
Power Recovery
The radio turns on when re-applying the supply voltage automatically with the
last saved setting (volume, channel 1-9).
Beeping tone dialing (3x “beep”)
The boundaries of the selectable frequency band at the transmitter scans have
been reached, or an incorrect entry in direct frequency entry are signaled by
3
x “beep”.
Battery replacement remote control
-
Lever (1) inwards
-
Pull out the battery drawer (2)
- (
Remove the old battery)
-
Install the new battery
-
Close the tray back
Note:
Only use suitable batteries.
Batterytype: Lithium3VCR 2025
Troubleshooting:
Continuous flashing of the LED
All functions of the radio are locked / deactivated.
Disconnect the radio for at least 10 minutes.
Noise:
Check the installation of electromagnetic influences
(
EMC Directive installation instructions!)
The device components can be fed to the disposal of plastic and metal
recycling and recycling of electronics parts.
Conformity with the product standards
CE conformity
FD51000. This product meets the CE marking criteria. The declaration of
conformity can be requested from the manufacturer.
Automatic assignment of the channel positions
The radio channels 1-9 can be assigned automatically
-
Press the “MEM” and then select “SCAN”
Note:
The search process may take a few minutes.
Manual fine tuning
The device allows manual fine-tuning of the radio
-
Press the “MEM” and then “0”
-
Change the frequency by pressing the “SCAN”
-
Save the setting with key numbers “1-9”
Note:
After about 2 seconds without any key operation of fine tuning is
finished. The keys “SCAN” then have their normal function.
Activation “PowerOff / Remind Settings”
Radio can be programmed so that it comes back on again in the
event of a power failure or when the ON / OFF switch is activated by
a light switch. This must be activated at the initial start PORS-function:
-
Press the “FREQ”
-
Pressing the key sequence “2” “2” “2” “1”
The action is confirmed with a “beep” twice.